Vacuum desk

Post Reply
User avatar
krokodil
Posts: 675
Joined: Tue Jan 29, 2013 6:46 pm

Vacuum desk

Post by krokodil »

Our son made me this small, very useful tool for miniatur SMD parts. It was always a challenge to solder wires to the SMD LEDs, how to hold them on the workbench and keep the LEDs steady when soldering.
IMG_4362.JPG
In this small box there is a small 12V vacuum pump and the surface is the back side of the standard copperplated material used for printed circuits. There are 5 bigger holes ( diameter 1,0mm) and among them four 0,5mm holes. Beneath there is a small soldered metalbox with a pipe connection to the vacuumpump. Ie the pump sucks over all 9 holes the air. I place the parts to the surface covering the hole ( the reaminig holes are covered by sticky tape, to increase the airflow over the hole). This keeps the small part on the surface and I can easily solder ( under magnifier) the wires to the parts.
Greetings from Austria
E.T.

User avatar
ConducTTor
Site Admin
Posts: 8857
Joined: Sat May 23, 2009 4:52 pm
Location: Atlanta GA USA
Contact:

Re: Vacuum desk

Post by ConducTTor »

Really cool. Can you post some pics of the interior/mechanism pls?
My website: https://www.ttnut.com
It's the website you're already on. But if you want to be even more on it, click the link.

Post Reply

Return to “Builders' Corner”