U30b chassis for Tillig Gear Tower

User avatar
Bernd
Posts: 977
Joined: Wed Sep 02, 2015 8:43 am
Location: Rochester, New York
Contact:

Re: U30b chassis for Tillig Gear Tower

Post by Bernd »

TiTan downunder wrote:>> That dimension from the left steps to the first clip will be 21.6mm <<

NO - 20mm - I measured from inside the step. Should have left that 1.6mm out - added confusion.

Ian
No problem Ian. We'll get it right yet. :smile:

Bernd
Image

User avatar
Bernd
Posts: 977
Joined: Wed Sep 02, 2015 8:43 am
Location: Rochester, New York
Contact:

Re: U30b chassis for Tillig Gear Tower

Post by Bernd »

Got my Sherline mill back in working order. Thanks to Rob for a quick diagnosis on what the problem could be. New lead screws installed and everything is working fine.

Here's the first .080" (2mm) thick chassis cut. The G-code still needs some tweaking.

Image

Instead of cutting pockets out for the tabs on the shell I milled a step .040" (1mm) thick. Should work better than pockets.

Image

Ian, PM sent.

Bernd
Image

Post Reply

Return to “Builders' Corner”