special requirements for priming, stiffening cardboard laser

Post Reply
User avatar
Rich1853
Posts: 328
Joined: Sun May 20, 2018 6:54 pm
Location: Melbourne, Florida USA.

special requirements for priming, stiffening cardboard laser

Post by Rich1853 »

Hello I'm interested in purchasing the my first laser cut structure, according to the specs the material says cardboard in the english translation. It also says the following:
A set for independent assembly and painting
A & S Project 122 - Lokschuppen Schleusinger Type: B 1: 120. Kit. New & Ovp.
Total length 25.4 cm., H = 11.0 cm. Laser cut, width 11.00 cm.
For priming I recommend Paraloid B72
It is recommended to stiffen the structure of cyanoacrylates possibly paraloid B72, it is on my other auction.
A & S Project 122 - Lok4schuppen Schleusinger Type: B 1: 120. Kit. New & Ovp.
Elements cut out by laser, materials that have moisture absorption properties (ie do not like moisture and should be avoided). For this reason you should pay attention to the dosing of water. The corners of the elements are slightly brownish due to the laser processing.
So what materials do all you modelers use.
Thanks

Rich1853
Greetings from Melbourne, Florida USA
On the Space Coast of Florida

Post Reply

Return to “Builders' Corner”