jmass wrote:i just bought a tillig tt starter set, but it does not come with transformer. the add for the set says 110 volt transformer needed. can i use a 120 mrc or will that destroy the engine. i bought the set from euro train hobby and the woman i talked to said they dont carry them.?
My Tillig starter set 01424 did come with a Tillig Controller 08132 but had the European AC plug on the plug in power supply. No problem I went on Amazon and match the DC output voltage needed and the diameter and polarity of the plug.
Normally I would just copy and paste the link but Amazon still has all my personal data because of my prior purchased on May 16, 2018
This is the plug in power supply that I purchased for my Tillig Controller
SMAKN (is the manufacturer)
4.7 out of 5 stars 42 Reviews
SMAKN AC 100-240V to DC 15V 2A Switching Power Supply Converter Adapter US Plug（6.5Ft）
About this item
*Input voltage: AC100-240V
*Output voltage: DC15V 2A
*Output Current: 2000mA
*Voltage Frequency: 50 / 60Hz
*Output ripple: 100MVP-P
*Input jack: US regulations
*Output line length: 2M
*Output Interface: 5.5mm (inner diameter) * 2.5mm (outside diameter)
*Plug polarity: the positive (+) outside negative (-)
*Anti-jamming performance, high reliability.
*DC ripple, high efficiency.
*Low temperature, long service life.
*Good insulation properties, high dielectric strength.
*Full load high temperature burn-in, 100% burn-in test.
*Suitable for security equipment, LCD, LED lighting, communications equipment, audition products, digital products, instruments and other products.