Siwtching Layout - 60' Thru Plate Girder Bridge

This sub forum is meant to be a model library. Feel free to add any information / pictures and your own reviews on models. If a topic on your model already exists, please add to it. Otherwise, start a new one.
dwyaneward
Posts: 108
Joined: Sun Nov 08, 2009 9:31 pm
Location: Fairview, Texas

Re: Siwtching Layout - 60' Thru Plate Girder Bridge

Post by dwyaneward »

For those who did not like the ballast deck. I drafted up a bridge tie section for code 55 rail and had it 3D Printed

Image

Image

Image

Image

Ties are12' long. The rail press fit into the rail alignment clip nicely, so a little glue should do it.

There are 20', 40' and 60' section 12' wide available on my Shapeways site.
Dwyane Ward | Fairview, TX
------------------------------------
My TT Scale Modeling Blog
Texas & Pacific - Bonham Division in N Scale
KD Models -3D Printing

Post Reply

Return to “TT Scale Models”